Lasermad.com

Hi Tony, Is the cathode cleaning routine activated in the 5-Relay module? I ask the question because I don't see any cathode cleaning triggered (as it is the case in the IN-14 kit and the cylinder clock) I had a look at the source asm code and I saw some code ready for the cleaning: incf Cleanbyte,f...

Hi Lee, thank you so much for your comments ! 8-) When you write "...but now the #6 LED is not working at all..." you mean the Led under the right tube or the last Led (the one under the clock on the right side)? If this is the led under the right tube, it is strange because if this Led is...

Hello, this is related to this image: On the upper right corner, this is the location where , instead of soldering the "piece of wire" that will connect the 433module to the PCB, you will solder the antenna (17,3 cm of wire)... http://www.lasermad.com/instructions/TimeFlies/Mouse1/MousePCB...

Today is a great day because I completed my Time Flies kit ! This is by far the best experience in electronics since many years. I would like to thank Tony for this great kit, for his support and his kindness... It was not so easy to assemble and to fine tune it. I would like to share my experience ...

Well I successfully figured out what my problem was with the touch sensor. The pin outs on the sensor are not in the order of Ground VCC the I/O the I/O pin is in the middle and I had reversed the VCC and IO pins. After this correction everything function just as it was described in the directions....

Hello, I am interested in getting more information related to the code to pilot the WS2812b LEDs. The LEDs works correctly but I don't understand how it can be. I study the source code and I don't understand how it can work for two reasons (see below). I probably missed something, could you help me ...

A little hint for the Battery switch: Be aware that the switch is connected to nothing on the PCB. If you want to use it to switch off the batteries, you will have to connect it with a strap to the + batteries connection pad. The connection is described in the attached pictured (strap in Green color).

Here is the electronic diagram. As it is a little bit complex to draw from the tracks, do not hesitate to mention if you see any mistake... I triple checked it but an error is always possible!

Hi Tony, in the PCB assembly (page1) you wrote: Now a modification before going any further. There's a track connecting the HV capactiros to the main HV rail here: Image It's under the resistor in the previous pictures but you can see where the PCB has been cut. Cut through this track as it's now co...

Hello, here is the electronic diagram. Feel free to send me your remarks if you detect some mistakes.
I represent R9 and C11 but It seems that they are connected to nothing since T1 is no more needed ???
I am not sure of D5 value: I suppose it is a 1N4148. @Tony: can you confirm?