Black PCB Chessboard


Discussion for purchasers of our original IN-7 Nixie chessboard

Posts: 5

Joined: Sun Jan 27, 2013 1:48 am

Post Tue Jan 29, 2013 3:14 am

Black PCB Chessboard

Here is the first test of my chess board. I populated a single row on the mainboard just to make sure it was all working,

More pics to follow
Attachments
NixieChessTestDSC00856.jpg
NixieChessTestDSC00856.jpg (137.1 KiB) Viewed 14430 times

Posts: 5

Joined: Sun Jan 27, 2013 1:48 am

Post Tue Jan 29, 2013 5:12 am

Re: Black PCB Chessboard

Here is a photo of the populated single row on the main board. The 5 volt Zener Diodes (1N5231B) are the ones around the Pic microcontroller. The 12 volt Zeners (1N5244B) are the ones on the far left and far right of the photo. All the diodes (12V & 5V) have the polarity stripe side closest to the Pic micro.

I mixed up the 5 volt diodes with the 12 volt diodes first time round but picked up the mistake before I placed the Pic micro. I swapped them around and everything worked fine.

Tony suggested the following tests before and after fitting the Pic:

"For quick power points the vertical link on the centre right is 0V and
any point on the ferrites will be OK for 12V. It should only draw a
couple of mA at this point through the 1k5 resistor next to the pic.
Once the pic is fitted the 2 links between the ferrites carry the
mosfet drive, check them for about 2.5V or a scope for 70khz"
Attachments
Main Board Single Row.jpg
Main Board Single Row.jpg (156.71 KiB) Viewed 14423 times
1N5231B.jpg
1N5231B.jpg (115.58 KiB) Viewed 14423 times
1N5244B.jpg
1N5244B.jpg (104.17 KiB) Viewed 14423 times

Return to Nixie Chessboard V1

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software