Piece base case

Assembly instructions for our limited edition OXO board
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Piece base case

Post by Tony »

Really all that's needed is sand the top flat (wet sanding is best). Round off the edges and engrave the top if you want or leave it as is - then colour the piece with gold/silver paint/coloured wax/whatever you want to use. Drop the piece PCB assembly in and use a little glue (from the top) to hold it in place. Push in the nixie.
I used hot melt engravers wax for the ready built board pieces - despite the burned fingers it does work well.
jmmcg
Posts: 56
Joined: Sat Apr 11, 2020 2:45 pm

Re: Piece base case

Post by jmmcg »

I note that the NIXIE holders have an internal shoulder onto which the PCB sits so the pins of the NIXIE show. Yet when I try to sit PCB (with a NIXIE with clean pins) in it, the NIXIE will not strike. With the top board & as a test with the base board on top (for a double thickness) the NIXIE strikes, but at the height of the internal shoulder (in the holder) this raises the pick-up coil (on the NIXIE PCB) too high and it simply will not strike. Can you advise me please?
jmmcg
Posts: 56
Joined: Sat Apr 11, 2020 2:45 pm

Re: Piece base case

Post by jmmcg »

jmmcg wrote:I note that the NIXIE holders ... XXXsnipXXX .... Can you advise me please?
Ooops. *shame* I had them upside down. They are fine. Apologies.
Post Reply