Case assembly


Site Admin

Posts: 950

Joined: Tue Jul 24, 2012 8:05 pm

Post Sat May 13, 2017 6:09 pm

Case assembly

Once you've finished testing the receiver works it can be built into its case. This is a simple stack of laminate rings held together by 4 M3 bolts, they'll need to be sanded before use.
Start with the case back - the piece drilled for the socket and LEDs:

Image

Push the 4 bolts through the corner holes - don't use washers - and turn upright:

Image

Site Admin

Posts: 950

Joined: Tue Jul 24, 2012 8:05 pm

Post Sat May 13, 2017 6:13 pm

Re: Case assembly

Drop on one small ring:

Image

Image

Site Admin

Posts: 950

Joined: Tue Jul 24, 2012 8:05 pm

Post Sat May 13, 2017 6:14 pm

Re: Case assembly

Then the PCB:

Image

Followed by alternating small and large rings until they're used - the last one on the stack should be a small ring:

Image

Site Admin

Posts: 950

Joined: Tue Jul 24, 2012 8:05 pm

Post Sat May 13, 2017 6:18 pm

Re: Case assembly

Fit the antenna in the cutout space and use the sticky tape on the wire to keep it tidy:

Image

Drop the lid on and bolt together. You should have a case that looks like this:

Image

Stick the 2 rubber feet from Bag1 onto the underside (the laminations under the USB socket which should be flat) so it stands vertically with the antenna at the top.

Return to 1 - GPS mouse

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software