4 - Case Assembly

Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Next another layer of 1x long wide strip with 3mm holes and 2x short wide strips with 3mm holes:

Image

Image

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Then a layer of narrow strips:

Image

Followed by another wide:


Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Yes it's more narrow strips!

Image

Followed by another layer of wide strips:

Image

And a final layer of narrow strips. The bolts will be almost covered by now.

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

The next part is built up on the underside of the lid. Starting with the paxolin lid, put the 6x blind hex nuts through the outer holes and turn upside down. Ignore the nut in the centre, it's just to allow the camera to focus.

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Build a layer of narrow strips with 1x long narrow and 2x short narrow, with 5.5mm holes:

Image

Image

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Followed by a layer of wide strips with 1x long wide and 2x short wide, with 5.5mm holes:

Image

Image

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Repeat for another narrow and wide layer. You'll have 4 layers at this point, with the last just over the nuts.

Image

Image

You'll probably want to tack them in place with hot melt glue or foam pads.
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: 4 - Case Assembly

Post by Tony »

Line up the base and lid sections so the short and long strips overlap as shown:

Image

Drop the lid onto the base and start fighting to get the 3mm bolts into the blind nuts before it falls apart. It'll need a bit of wriggling but you should feel them drop into place. Tighten each a couple of turns to prevent it falling out then check nothing has dropped out of place. If it's OK, tighten the bolts up but not too much or it will distort the lid.

Image

The stack of strips should look like this:

Image
Locked