Page 1 of 1

4 - Case Assembly

Posted: Fri Dec 01, 2017 6:35 am
by Tony
Put the 2x M3 bolts through the coil assembly end holes as shown:

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:04 am
by Tony
Now the magnet. Every ferrous tool I own is now magnetic after 2 + years of working with these things. Keep it away from anything it can attract, that includes tiny components and wire offcuts.

As supplied it has a steel weight stuck to the top, this will need to be removed before using it. The glue used is quite weak but the magnetic hold is strong, you'll need to force it apart at this groove - how you do it is up to you - I've removed many of them easily but I can't suggest how just in case it causes injury.

Image

Do not heat it up to soften the glue, it doesn't need to be so just keep it at or close to room temperature as the Curie point for these super-strong magnets is quite low.

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:13 am
by Tony
Push the magnet into the coil assembly as shown - you may need to sand or Dremel the edges of the hole slightly as there's very little clearance.:

Image

Stick the 3 double sided adhesive foam pads onto the magnet as shown above but leave the wax paper on the top side so they're not sticky:

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:17 am
by Tony
Now drop the second 'narrow, shaped' loop onto the coil assembly - you can now see they're shaped to fit around the magnet:

Image

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:24 am
by Tony
Now one of the 'Wide plain' loops:

Image

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:29 am
by Tony
Solder the 2 coil wires to the clock PCB and drop it onto the stack, making sure the wires don't foul anything. There should be about 7mm of empty space for them under here:

Image

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:31 am
by Tony
Followed by another 'wide plain' ring:

Image

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:32 am
by Tony
Followed by a 'narrow plain' ring:

Image

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:33 am
by Tony
And the last 'wide plain' ring:

Image

Followed by the last 'narrow plain' ring:

Image

Should leave you with this:

Image

Re: Case Assembly

Posted: Fri Dec 01, 2017 7:37 am
by Tony
Finally the case lid:

Image

Bolt this down using the 2x brass washers and M3 nuts to complete the Beacon module assembly.

Finally, glue the felt disc to the smaller of the magnets under the Relay base. This provides some protection for the base lid when the clock inevitably drops into it.