Page 1 of 1

Board coils

Posted: Sun Sep 16, 2012 12:20 am
by Tony
For this you will need the entire contents of BAG 2 plus the M5 nuts and bolts from BAG 1 and copper wire.

Image

Re: Board coils

Posted: Sun Sep 16, 2012 12:25 am
by Tony
.$200
ldx #$41

Assembling the coil former:

You will need one 0.8mm coil top either brown or white, one 1.5mm thick spacer, one 1.5mm base and one 1.5mm thick terminal holder:

Clean up any loose material using sandpaper or a knife.

Image

Assemble the pieces onto one of the M5 bolts in this order then run a couple of drops of superglue into the groove and round the edge of the terminal holder to hold the pieces together:

Image

Thread the copper wire through one of the terminal holder holes and wrap enough around the bolt to hold it in place:

Image

Wind 55 turns around the spacer in the groove formed between the coil ends as you did with the display piece coils, cut leaving a couple of inches of wire and feed this end through the other terminal holder hole. If you find the resulting display a little dim reduce to 54. (Try a couple before winding the whole batch)

Varnish or glue the windings in place. Once the glue has dried remove the bolt.

Repeat this another 64 times.

dex
bne $200

Are you still there?. :shock: