Piece display PCB

Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Piece display PCB

Post by Tony »

For this you will need the entire contents of BAG 4 plus solder from BAG 5.

230x Diodes - Copper-orange glass cylinders with a black band marking one end. These are polarised and must face the same way as in the photographs.

Capacitors - Brown ceramic discs. Seven of these are used on each board.

Capacitors - Green rectangles. One of these is used on each board.

Coils - Black plastic sleeved ceramic-like material. One of these is used on each board.

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

First fit the 7 ceramic capacitors:

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Next the 7 diodes, the band FACES the CIRCLED HOLE, that is the wire leading from the banded end foes through the hole marked with a circle:

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Then the 4n7 green capacitor:

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Finally, the prewound inductor. You'll need to carefully remove the protective plastc sleeve from it first.

Use one of the paxolin base covers to make sure it's at the right depth through the hole in the PCB. You want it to be just level with the bottom of the base cover.

Image

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Finally bridge these two pads with some solder:

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Dismantle the three 25 way 'D' sockets, the easiest way is to cut through one of the rivets then seperate the two halves of the shell.

Image

Open up the socket housing and remove the pins.

Image
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Fit two pins as shown and solder in place.

Image

Make four of these for use with 4x IN-15Bs: Bishops (Alfiere)
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Fit two pins as shown and solder in place.

Image

Make two of these for use with 2x IN-15As: King
Tony
Site Admin
Posts: 957
Joined: Tue Jul 24, 2012 8:05 pm

Re: Piece display PCB

Post by Tony »

Fit two pins as shown and solder in place.

Image

Make six of these for use with 4x IN-15As: Knight (Marchog) and 2x IN-15Bs: Queen (Vizier)
Post Reply