Help! Problem....

Advice on out-of the box setup, floating advice and any other hints
iworm
Posts: 2
Joined: Mon Feb 12, 2018 3:16 pm

Help! Problem....

Post by iworm »

Hello.

Help! The clock has worked fine for a long time, but recently there's a big problem. If the module is brought to the base, ready to float it, all (or most?) of the digits in all the tubes light up - and if I left it in position they stay that way (basically 'garbage' display, no time, multiple digits per tube). Not all light up the same, and I can send a photo if it helps.

My limited ability to troubleshoot suggests it's not a power issue (after all, more digits light up than normal!) and I have carefully inspected the module interior to check for anything really obvious like a short etc.

So I'm kinda stumped as to what to do. I have basic tools, multimeter, etc. so can check stuff if someone could guide me where to start.

Thanks!
Tony
Site Admin
Posts: 948
Joined: Tue Jul 24, 2012 8:05 pm

Re: Help! Problem....

Post by Tony »

Have you tried powering off for a couple of hours then trying again?. It sounds like the processor in the clock module isn't resetting and starting up correctly when powered. Beyond that it's probably a fault in the clock section.
iworm
Posts: 2
Joined: Mon Feb 12, 2018 3:16 pm

Re: Help! Problem....

Post by iworm »

Hi!

Thanks for the response (slow reply from me.... summer holiday period...)

I tried a lengthy full power-off - but same issue. :-(

If I sent the minimum component(s) to you (tell me exactly which!) would you be able to maybe fix this for me? Of course I would pay all transport plus your time/materials etc. - that's no problem. I just want to get it working again!!

Not sure if my email is in the board's profile? (Could not see it on a quick look) It's sgroarke AT gmail.com otherwise.

Hoping you can help.

Sean
Tony
Site Admin
Posts: 948
Joined: Tue Jul 24, 2012 8:05 pm

Re: Help! Problem....

Post by Tony »

It would be just the floating section itself and I'd be happy to repair it though it would be next month before I am back to being able to.
Post Reply