Page 1 of 1

UK USB power supply

Posted: Fri Dec 16, 2016 10:13 pm
by Tony
No longer supplied, left here for reference only.

First remove the original connector:

Image

Tin the 2 outer terminals of the USB plug:

Image

Image

Strip the outer insulation of the PSU cable back about 20mm then strip and tin the wire ends. Solder them as shown to the USB plug.

If you have a power supply with black and green wires use this photo:

Image

If you have a power supply with red and green wires use this photo:

Image

Finally use the 2 black plastic housing pieces to finish the plug assembly.